» filter » Camp Fire Safety
filter emc

Camp Fire Safety

Camp Fire Safety

How to Pick Your Spot

Follow these steps when picking your burning site to promote wildfire safety:

* DO NOT build a fire at a site in hazardous, dry conditions. DO NOT build a fire if the campground, area, or event rules prohibit campfires.

* FIND OUT if the campground has an existing fire ring or fire pit.

* If there is not an existing fire pit, and pits are allowed, look for a site that is at least fifteen feet away from tent walls, shrubs, trees or other flammable objects. Also beware of low-hanging branches overhead.

Note: in some areas digging pits are not allowed because of archaeological or other concerns. Find out the rules in your area please.

Dig A Pit Whether building a campfire pit yourself, or preparing a pit that you found on your campsite, there are some safety tips you should follow.

Building Your Campfire Pit from Scratch

Some campsites have unsuitable pits or may not offer pre-made pits at all. If this is the case:

1. Choose a spot that's downwind protected from wind gusts, and at least 15 feet from your tent and gear.

2. Clear a 10-foot diameter area around the site. Remove any grass, twigs, leaves and firewood. Also make sure there aren't any tree limbs or flammable objects hanging overhead.

3. Dig a pit in the dirt, about a foot deep.

4. Circle the pit with rocks.

5. Your campfire pit is built and ready for preparation!

Preparing Your Campfire Pit:

Before you start your campfire, you need to prepare your pit.

1. Fill the pit with small pieces of dry wood; never rip or cut branches from living trees.

2. Place your unused firewood upwind and away from the fire.

3. Keep a bucket of water and a shovel nearby.

How to Build a Campfire Now that you have prepared your pit, it's time to build your campfire. Follow these steps to have a safe and fun time.

1. Gather three types of wood

* Tinder (small twigs, dry leaves or grass, dry needles)

* Kindling (sticks smaller than 1 around)

* Fuel (larger pieces of wood)

2. Loosely pile a few handfuls of tinder in the center of the fire ring/pit

3. Add kindling in one of these methods:

* Tipi (Good for cooking)

Lay the kindling over the tinder like you're building a tent.

* Cross (Perfect for a long-lasting campfire)

Crisscross the kindling over the tinder.

* Lean-to (Good for cooking)

Drive a long piece of kindling into the ground at an angle over the tinder. Lean smaller pieces of kindling against the longer piece.

* Log Cabin (Longest lasting campfire)

Surround your pile of tinder with kindling, stacking pieces at right angles. Top the "cabin" with the smallest kindling.

4. Ignite the tinder with a match or lighter

5. Wait until the match is cold, and discard it in the fire

6. Add more tinder as the fire grows

7. Blow lightly at the base of the fire

8. Add kindling and firewood to keep the fire going

9. Keep the fire small and under control

How to Put Out the Campfire

A roaring fire is both a success, and a responsibility. It is your job to properly maintain and extinguish your campfire so that future campers can do the same.

Maintaining Your Campfire

As you're enjoying your campfire, remember these safety tips:1. Once you have a strong fire going, add larger pieces of dry wood to keep it burning steadily

2. Keep your fire to a manageable size

3. Make sure children and pets are supervised when near the fire

4. Never leave your campfire unattended

5. Never cut live trees or branches from live trees

Extinguishing Your Campfire When you're ready to put out your fire and call it a night, follow these guidelines:

1. Allow the wood to burn completely to ash, if possible

2. Pour lots of water on the fire, drown ALL embers, not just the red ones

3. Pour until hissing sound stops

4. Stir the campfire ashes and embers with a shovel

5. Scrape the sticks and logs to remove any embers

6. Stir and make sure everything is wet and they are cold to the touch

7. If you do not have water, use dirt. Mix enough dirt or sand with the embers. Continue adding and stirring until all material is cool. Remember: do NOT bury the fire as the fire will continue to smolder and could catch roots on fire that will eventually get to the surface and start a wildfire.

REMEMBER: If it's too hot to touch, it's too hot to leave!

Don't burn dangerous things!

* never burn aerosol cans or pressurized containers. They may explode.

* never put glass in the fire pit. Glass does not melt away, it only heats up and shatters. Broken slivers of glass are dangerous.

* aluminum cans do not burn. In fact, the aluminum only breaks down into smaller pieces. Inhaling aluminum dust can be harmful to your lungs. Pack it in, Pack it out.

* be sure to pack out your trash. It is your responsibility to pack out everything that you packed in.
Safety Work Procedure Wireless temperature & HACCP food safety monitoring solution PPE Suppliers Advice - The Five Point Safety Strategy Five Safety Features of 4x4s and 4WD SUVs Let us talk about LED circuit 5 Licensed Electrician Tips for Safety at Home All About Health And Safety Training Courses Why do you need safety glasses at work? BlackBerry phones- QWERTY comes to quicken your electronic communication Electronic Health Records – Reasons To Move Forward With Implementation 3 Fundamental Safety Measures For the Internet Hosting Records Air News On Learning To Fly: Circuit Work,tHe 'first' and 'second' Nature By Johan Lottering Electronic Air Cleaners - The 5 Major Types
Write post print guest:  register | login | search IP( / Processed in 0.020561 second(s), 5 queries , Gzip enabled debug code: 124 , 5356, 954,
Camp Fire Safety